Bachmann Dynamis User's Guide download pdf

Dynamis ProBox

Printed in China Dynamis ProBox User Guide V02 Jan 09

3.10 ECoSLink connection

Dynamis can be connected to an ESU ECoS using a ECoSLink connector (supplied

separately). Please refer to www.dynamisdcc.com for more information

The icon indicates connection to ECoS.

3.11 Additional Dynamis Components

Further components in the Dynamis range are available to expand the operation of the system

Handset item 36-507 Up to a total of 4 handsets may be used so that up to 4

trains are under separate control at once

IR receiver item 36-509 Up to a total of 5 IR receivers may be connected to the

IR Expander to give IR coverage for a larger layout

www.dynamisdcc.com

Dynamis ProBox

1 Introduction

This document describes how to use the Pro Box to expand the features of the E-Z Command

Dynamis DCC system. It covers how to connect it together, how to use the additional features

and how to add an additional handset (sold separately) to the entire system. Where necessary,

please refer to the E-Z Command Dynamis User Guide.

At the Pro level Dynamis remains an easy-to-use DCC system, however it is very important

that certain procedures are be carried correctly - please read and follow the instructions

carefully.

The term “Basestation” refers to either the Command Station or the Command Station and Pro

Box combination as appropriate.

2 Making the connections

2.1 Connecting the Pro Box

1 Switch off the handset

2 Power off the Dynamis Command Station

3 Attach the Pro Box to the Command Station by putting them together. The

Command Station fits on the top of the Pro Box. Any BASE ID jumpers to

allow more than one Dynamis system to be used in proximity are fitted to

the pins on top of the Pro Box (section 3.9)

IR Receiver

IR Extension

Command station

(supplied in 36-505)

Pro Box

Pro Box User Guide

1 2 3 4

Summary of Contents

Page 1 - Pro Box User Guide

8Dynamis ProBoxPrinted in China Dynamis ProBox User Guide V02 Jan 093.10 ECoSLink connectionDynamis can be connected to an ESU ECoS using

Page 2 - Dynamis ProBox

2Dynamis ProBox2.2 Connecting the IR Extension module 1 Remove the IR Receiver from the top of the Command Station 2 Plug the IR Extension module

Page 3 - 3 Operation

6Dynamis ProBox “Factory Reset” in the “System Menu” of a Handset you will only reset the applicable Handset. If it is in range of a Pro Box with t

Page 4 - LOCOMOTIVE LIST?

4Dynamis ProBoxIf the Pro Box cannot determine which locomotive roster to use the user will be asked on the Handset which to use: OK TO RESET INT LOCO

Comments to this Manuals

No comments

Bachmann Dynamis User's Guide

Browse online or download User's Guide for Networking Bachmann Dynamis. Bachmann Dynamis User guide User Manual

Summary of Contents

Comments to this Manuals